Free IBM 000-332 Exam Dumps Questions & Answers

An administrator tries to replace a hot-plug Ethernet adapter using the C-CPOC > Communication Interfaces SMIT menu. When prompted, the administrator selects the incorrect adapter and does not wish to continue. When prompted to confirm adapter replacement, he selects "no".
What is the first action that the administrator must take to restore cluster to the pre-maintenance condition?

• A.  Run the cfgmgr command to re-detect the adapter and create the device special files
• B.  Run Cluster Verification and Synchronization to reset the adapter state.
• C.  Migrate the resource groups using the adapter back to the node.
• D.  Run the drslot command to take the PCI slot out of the "removed" state.

In PowerHA 7 cluster, how many multicast IP addresses are required?

• A.  One for each network in the cluster
• B.  One for the entire cluster
• C.  One for each node in the cluster
• D.  One for each node of each network in the cluster

A shared volume group is added to a resource group and verification of the change produces an error. What is the most likely reason?

• A.  The names of one or more disks in the volume group do not match on all the nodes in the resource group.
• B.  The volume group major number is different on some nodes in the cluster.
• C.  The auto vary on flag is set to "yes".
• D.  The volume group is varied off on all of the nodes.

What must be considered when planning a PowerHA 7 cluster using Cluster Aware AIX (CAA)?

• A.  An Enhanced Concurrent Volume Group in Scalable mode.
• B.  A repository logical volume that is at least 10GB, and is shared by all nodes in the cluster
• C.  A SAS or SAN disk that is shared by all nodes in the cluster
• D.  A shared storage pool that is at least 10GB, and is accessible by all nodes in the cluster

An active, active (mutual takeover) 2-node PowerHA cluster is currently up and stable. Both nodes are located in separate buildings, one kilometer apart. Node2 in SiteB suddenly powers off. On reboot of the failed node, the cluster administrator checks the error log and discovers the node had been halted. The network team confirms there was a temporary loss of the IP network between sites.

Why did Node2 halt?

• A.  Node2 was automatically set to halt on loss of the IP network.
• B.  On loss of the IP network, Node1 sent a halt signal to Node2 via the disk heartbeat network.
• C.  The cluster became partitioned. On recovery of the IP network, Node1 sent a halt signal to Node2.
• D.  On loss of the IP network the grpsvcs daemon crashed, causing Node2 to halt.