Free IBM C2150-620 Exam Dumps Questions & Answers

An Administrator has just configured a new XGS appliance to run in FIPS mode. After deploying the company policies to the appliance, the Administrator realizes the User Authentication feature is not working.
What is the likely cause of the problem?

• A.  TLS 1.0 and 1.1 are not enabled.
• B.  The FIPS integrity check failed to run.
• C.  User Authentication is not supported in FIPS mode.
• D.  The appliance was not restarted.

A System Administrator needs to reinstall and XGS 4100 device.
Which process step is required?

• A.  Create a bootable image from the file ISNP_5.3.2.3_20160526-0332.img
• B.  Create a bootable image from the file GX4000.4.6.2_2014.0609_01.40.11. usbimg
• C.  Create a bootable image from the file GX4000bootsrv.4.6.2_2014.0609_01.40.11 iso
• D.  Create a bootable image from the file ISNP_5.3.2.3_20160526-0332.pkg

The System Administrator has configured the XGS devices shown in the following topology diagram.
+

Which XGS devices will block a Cross Site Scripting (XSS) attack coming from an SSL enabled public web site on the Internet to the internal network?

• A.  XGS4 in monitoring mode using TCP RST
• B.  XGS3 in protection mode
• C.  XGS2 in monitoring mode using TCP RST
• D.  XGS1 in protection mode

A System Administrator wants to configure two XGS appliances in an active/active high availability (HA) setup so that network traffic can fail over to the secondary XGS without missing inspection of any packets. The diagram below shows the current cabling setup between the redundant firewalls and routers and the 4 built in ports on the XGS appliances:

What is wrong with the cabling diagram?

• A.  Two extra network cables are required: one from XGS A port 1.3 to XGS B port 1.3 the other from XGS A port 1.4 to XGS B port 1.4.
• B.  Four extra network cables are required: Cable 1) Firewall A to XGS B, port 1.3; Cable 2) Firewall B to XGS A, port 1.3; Cable 3) XGS A, port 1.4 to Router B; Cable 4) XGS B, port 1.4 to Router A.
• C.  One extra network cable is required between XGS A and XGS B. It can be plugged into either port 1.3 or 1.4 as long as it is the same port on both XGS appliances.
• D.  The incorrect ports are being used on XGS B. The firewall and router should be plugged into ports 1.3 and 1.4 respectively.

A financial company plans to deploy an XGS appliance to protect the company network and has the following requirements:
* 6.5 Gbps total inspected throughput
* Average latency must be less than 150 microseconds
* 4 Gbps inspected outbound SSL throughput
* Active-Passive HA deployment
Which model and NIM option will fulfill these requirements?

• A.  XGS 7100; two 2-port 10 GbE SFP + NIM & SR transceivers
• B.  XGS 5100; two 2-port 10 GbE SR NIM
• C.  XGS 5100; 2-port 10GbE SFP+NIM & SR transceivers
• D.  XGS 7100; 2-port 10GbE LR NIM