Time-to-market can be reduced MOST directly through the use of:
Response:

• A.Concurrent engineering
• B.Highly accelerated stress screening (HASS)
• C.Reliability centered maintenance (RCM)
• D.Field testing.

Comment: *

Name: *

Email: *

Verification: *

A resistor is rated at 1 watt. One example of using this resistor in a derated condition is using:
Response:

• A.The resistor in a 0.5 watt application.
• B.Two of the resistors in series.
• C.The resistor in a 2 watt application.
• D.The resistor as a standby unit.

Comment: *

Name: *

Email: *

Verification: *

Preliminary hazard analysis:
I. Is a review of safety problems prior to production.
II. Is normally done at a time when there is little design detail.
III. Can be used to identify the principal hazards when the product is first conceived.
Response:

• A.I, II and III
• B.I and II only
• C.I only
• D.III only

Comment: *

Name: *

Email: *

Verification: *

Maintainability considerations are important in the design of:
Response:

• A.Consumer televisions.
• B.Integrated circuits.
• C.Unmanned satellites.
• D.Modern automobiles.

Comment: *

Name: *

Email: *

Verification: *

The predicted reliability is higher than the long term realized probability. Which of the following is the MOST likely cause of this difference?
Response:

• A.Lack of adequate employee training and process audits.
• B.The accumulation of random process variations.
• C.Deterioration of the manufacturing processes and procedures.
• D.A poor initial estimation of reliability.

Comment: *

Name: *

Email: *

Verification: *