You are configuring Personal Station Access (PSA) in Communication Manager with the following settings: a/ Set TTI enabled = 'y', b/ Set PSA Associate code =*25' and dissociate code = '#25', c/Set security code for the station = '1234'. .
You activate the station by keying in the FAC for PSA, the station extension number,
'#', the security code of the station, and '#'. However, the station is not activated.
Which statement describes the issue to be addressed?

• A.You should not set the security code in sequential order.
• B.You did not key in the correct activation sequence.
• C.You did not enable PSA on the COS of the station.
• D.You need to set TTl= 'n'.

Comment: *

Name: *

Email: *

Verification: *

The monitor commands can be used to get a real time status of the system from SAT.
Which command is incorrect command?

• A.monitor security-violations command
• B.monitor trace station command
• C.monitor system view command
• D.monitor traffic command

Correct Answer: B

Comment: *

Name: *

Email: *

Verification: *

A customer wants to connect two branch offices with an ISDN trunk, where each branch office has a PBX system.
Which Service Type should be selected when configuring the trunk?

• A.Tandem
• B.Central Office (CO)
• C.Direct Inward Dial (DID)
• D.Tie

Comment: *

Name: *

Email: *

Verification: *

When adding an IP Station type 96XX, which statement is true regarding the PORT field?

• A.It must be populated as "S000XX".
• B.It must be populated with an available port on an MM712 or TN2214.
• C.It is automatically populated by the system as "IP".
• D.It must be populated with an available port on the LAN switch.

Comment: *

Name: *

Email: *

Verification: *

Which type of phone doesn't support Station Lock feature in Communication Manager R8.1?

• A.Digital
• B.Analog
• C.H.323
• D.SIP

Comment: *

Name: *

Email: *

Verification: *