Free Avaya 6101.1 Exam Dumps Questions & Answers

One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced.
The auto unit replacement (AUR) is enabled but the stack is not functioning properly.
What is the problem?

• A.  The switches in the stack are not running the same release of software
• B.  The switches in the stack are not identical
• C.  the stack power was left on during the switch replacement.
• D.  The stack has two switches with Force Stack disabled.

Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

• A.  the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.
• B.  RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.
• C.  RSML T dynamically balances the CPU load across the switch cluster.
• D.  RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.
• E.  RSMLT edge is easier to configure and lightens the CPU load,

Ethernet Routing Switch (ERS) 5500 portfolio shares a number of common hardware features.
Which feature is unique to the ERS 5530 and is not available on the other ERS 5500 switches?

• A.  Console serial port
• B.  Universal Serial Bus (USB) port
• C.  User Interface push button
• D.  Network management Ethernet port

Click on the exhibit button After checking the VLAN configuration using the show vlan info basic and the show vlan info port commands, there are no ACTIVE MEMBER ports for VLM4-50.

What is causing this problem?

• A.  The ports have not been configured as active for this VLAN
• B.  There are no devices connected to these ports.
• C.  The default setting for this type of VLAN is potential and no AppleTalk traffic has entered any of these ports
• D.  AppleTalk Protocol VLANs do not have ACTIVE MEMBERS

1ST configuration using the show mlt ist info command, which IP address should be in the IP ADDRESS column?

• A.  the IP address of the IST VL AN on the peer switch
• B.  the IP address of the IST on the peer switch
• C.  the IP address of the ISTVLAN on the local switch
• D.  the management IP address of the peer switch