A Blue Prism solution works fine when developing and testing it in Process and Object studio but when it is ran in Control Room exceptions occur because of screen elements not being found. What is the most likely cause?

• A.The most likely cause for the errors is that your application has changed.
• B.The most likely cause for the errors seen in Control Room is that best practice use of wait stages has not been followed.
• C.The most likely cause for the errors is that the Object Studio action has not been published and therefore cannot be used by the Process in control room.
• D.The most likely cause for the exceptions is that best practice exception handling has not been incorporated into the Process.

Comment: *

Name: *

Email: *

Verification: *

Consider the following process flow:

Decision JA" properties are:

Decision "B" properties are.

Decision "C" properties are

What will happen when the process runs?

• A.An exception will be thrown
• B.The flow will pass through calculation stage "A"
• C.The flow will pass through calculation stage "C"
• D.The flow will pass through calculation stage "B"

Comment: *

Name: *

Email: *

Verification: *

The Order System application has been successfully launched and Blue Prism has navigated the application to the following screen:

There is a requirement to ensure this screen is in focus before any further interfacing is done with the screen. Which is the correct configuration to ensure the New Order screen is in focus?
A)

B)

C)

D)

• A.Exhibit A
• B.Exhibit B
• C.Exhibit C
• D.Exhibit D

Comment: *

Name: *

Email: *

Verification: *

Examine the process flow:

The Process is intended to attempt to perform the processing in the recover block, Block 3, a maximum of three times before throwing an exception.
Data Item "Attempts" is a number data item with an initial value of 0
Data Item "Max Attempts" is a number data item with an initial value of 3 The 'Increment Attempts' calculation stage outputs a result to the "Attempts" data item To enable this to work correctly, what is the correct expressions for the 'Increment Attempts' calculation stage?

• A.+1
• B.[Max] + 1
• C.[Attempts] + 1
• D.Attempts + 1

Comment: *

Name: *

Email: *

Verification: *

How many Start Stages can a sub-page in a Process have?

• A.0
• B.1
• C.2
• D.Any Number

Comment: *

Name: *

Email: *

Verification: *