What can an impedance mismatch in the RF cables and connectors cause?

• A.Excessive VSWR
• B.Fewer MCS values in the MCS table
• C.Increased range of the RF signal
• D.Increased amplitude of the RF signal

Comment: *

Name: *

Email: *

Verification: *

You are troubleshooting a problem with interference from a non-802.11 device. Given that the device is not a WLAN device, you cannot use a protocol analyzer and have chosen to use a spectrum analyzer. You want to view the signal from the interfering device over time to sec the activity that it is generating. What common spectrum analyzer view should you use for this analysis?

• A.Clients
• B.Waterfall/Spectrogram
• C.Real-Time FFT
• D.APs

Comment: *

Name: *

Email: *

Verification: *

In addition to coverage analysis results, what should be included in a post-deployment site survey report to ensure WLAN users experience acceptable performance?

• A.WAN interface analysis results
• B.Capacity analysis results
• C.Application Layer protocol availability analysis results
• D.Layer 4 protocol availability analysis results

Comment: *

Name: *

Email: *

Verification: *

In an infrastructure Basic Service Set (BSS), how does the passive scanning process occur?

• A.Access points broadcast Beacons on a single channel for which they are programmed. Nearby client stations listen for Beacon frames and record information found in the Beacons for use in the association process.
• B.Client stations broadcast Probe Request frames on the single channel for which they are programmed. Nearby access points respond on that channel with Probe Response frames. Client stations record information found in the Probe Response frames for use in the association process.
• C.Access points broadcast Beacons on all channels of each radio within the regulatory domain.
  Nearby client stations record information found in the Beacons for use in the association process.
• D.Client stations broadcast Probe Request frames on all supported channels in the regulatory domain. Nearby access points respond with Probe Response frames. Client stations record information in the Probe Response frames for use in the association process.

Comment: *

Name: *

Email: *

Verification: *

In which plane of the three networking planes is an access point configured by a WLAN controlled?

• A.Security
• B.Data
• C.Control
• D.Management

Comment: *

Name: *

Email: *

Verification: *