CPU-level of your Security gateway is peaking to 100% causing problems with traffic. You suspect that the problem might be the Threat Prevention settings.
The following Threat Prevention Profile has been created.

How could you tune the profile in order to lower the CPU load still maintaining security at good level? Select the BEST answer.

• A.Set the Performance Impact to Very Low Confidence to Prevent.
• B.Set the Performance Impact to Medium or lower.
• C.Set High Confidence to Low and Low Confidence to Inactive.
• D.The problem is not with the Threat Prevention Profile. Consider adding more memory to the appliance.

Comment: *

Name: *

Email: *

Verification: *

Fill in the blank: The R80 SmartConsole, SmartEvent GUI client, and _______ consolidate billions of logs and shows them as prioritized security events.

• A.SmartMonitor
• B.SmartView Web Application
• C.SmartReporter
• D.SmartTracker

Comment: *

Name: *

Email: *

Verification: *

If there is an Accept Implied Policy set to "First", what is the reason Jorge cannot see any logs?

• A.Log Implied Rule was not set correctly on the track column on the rules base.
• B.Track log column is set to Log instead of Full Log.
• C.Track log column is set to none.
• D.Log Implied Rule was not selected on Global Properties.

Comment: *

Name: *

Email: *

Verification: *

If an administrator wants to restrict access to a network resource only allowing certain users to access it, and only when they are on a specific network what is the best way to accomplish this?

• A.Create an inline layer where the destination is the target network resource Define sub-rules allowing only specific sources to access the target resource
• B.Create an Access Role object, with specific users or user groups specified, and specific networks defined Use this access role as the "Source" of an Access Control rule
• C.Use a "New Legacy User At Location", specifying the LDAP user group that the users belong to, at the desired location
• D.Create a rule allowing only specific source IP addresses access to the target network resource.

Comment: *

Name: *

Email: *

Verification: *

What does it mean if Deyra sees the gateway status:

Choose the BEST answer.

• A.SmartCenter Server cannot reach this Security Gateway
• B.There is a blade reporting a problem
• C.VPN software blade is reporting a malfunction
• D.Security Gateway's MGNT NIC card is disconnected.

Correct Answer: B

Explanation
If Deyra sees the gateway status as shown in the image, it means that there is a blade reporting a problem.
The red "X" in the status column indicates that one or more blades on the Security Gateway have a problem that requires attention. The other options are not correct, as they do not match the status shown in the image. If the SmartCenter Server cannot reach this Security Gateway, the status column would show a yellow triangle with an exclamation mark. If the VPN software blade is reporting a malfunction, the blades column would show a red "X" on the VPN icon. If the Security Gateway's MGNT NIC card is disconnected, the IP column would show "N/A" instead of the IP address.
References: Remote Access VPN R81 Administration Guide, Check Point R81.10

Comment: *

Name: *

Email: *

Verification: *