There are two R77.30 Security Gateways in the Firewall Cluster. They are named FW_A and FW_B. The cluster is configured to work as HA (High availability) with default cluster configuration. FW_A is configured to have higher priority than FW_B. FW_A was active and processing the traffic in the morning. FW_B was standby. Around 1100 am, its interfaces went down and this caused a failover. FW_B became active. After an hour, FW_A's interface issues were resolved and it became operational.
When it re-joins the cluster, will it become active automatically?

• A.No, since 'maintain' current active cluster member' option is enabled by default on the Global Properties.
• B.Yes, since 'Switch to higher priority cluster member' option on the cluster object properties is enabled by default.
• C.No, since 'maintain' current active cluster member' option on the cluster object properties is enabled by default.
• D.Yes, since 'Switch to higher priority cluster member' option is enabled by default on the Global Properties.

Comment: *

Name: *

Email: *

Verification: *

Selecting an event displays its configurable properties in the Detail pane and a description of the event in the Description pane. Which is NOT an option to adjust or configure?

• A.Severity
• B.Automatic reactions
• C.Policy
• D.Threshold

Comment: *

Name: *

Email: *

Verification: *

Which command collects diagnostic data for analyzing customer setup remotely?

• A.cpinfo
• B.migrate export
• C.sysinfo
• D.cpview

Comment: *

Name: *

Email: *

Verification: *

Which command shows the current Security Gateway Firewall chain?

• A.fw ctl chain
• B.fw ctl firewall-chain
• C.show firewall chain
• D.show current chain

Comment: *

Name: *

Email: *

Verification: *

In the Check Point Security Management Architecture, which component(s) can store logs?

• A.SmartConsole
• B.Security Management Server and Security Gateway
• C.Security Management Server
• D.SmartConsole and Security Management Server

Comment: *

Name: *

Email: *

Verification: *