Free CheckPoint 156-915 Exam Dumps Questions & Answers

By default, when you click file > Switch Active File from SmartView Tracker, the SmartCenter Server.

• A.  Purges the current log file, and starts a new log file.
• B.  Prompts you to enter a filename, then saves the log file.
• C.  Opens a new window with a previously saved log file.
• D.  Purges the current log, and prompts you for the new log's mode.
• E.  Saves the current log file, names the log file by date and time, and starts a new log file.

You are reviewing SmartView Tracker entries, and see a Connection Rejection on a Check Point QoS rule. What causes the Connecion Rejection?

• A.  No QoS rule exists to match the rejected traffic.
• B.  The Constant Bit Rate for a Low Latency Class has been exceeded by greater than
  10%, and the Maximal Delay is set below requirements.
• C.  The number of guaranteed connections is exceeded. The rule's action properties are not set to accept additional connections.
• D.  The guarantee of one of the rule??s sub-rules exceeds the guarantee in the rule itself.
• E.  Burst traffic matching the Default Rule is exhausting the Check Point QoS global packet buffers.

You users defined in a Windows 2000 Active Directory server. You must add LDAP users to a Client Authentication rule. Which kind of user group do you need in the Client Authentication rule in NGX?

• A.  External-user group
• B.  All Users
• C.  A group with generic* user
• D.  LDAP account-unit group
• E.  LDAP group

State Synchronizatioin is enable on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for "selective sync".
The following is the fw tab -t connections -s output from both members:

Is State Synchronization working properly between the two members?

• A.  Members A and B are not synchronized, because #VALS in the connections table are not close.
• B.  Members A and B are synchronized, because ID for both members is identical in the connections table.
• C.  Members A and B are not synchronized, because #PEAK for both members is not close in the connections table.
• D.  The connections-table output is incomplete. You must run the cphaprob state command, to determine if members A and B are synchronized.
• E.  Members A and B are synchronized, because #SLINKS are identical in the connections table.

What is the command to see the licenses of the Security Gateway FWDALLAS from you SmartCenter Server?

• A.  fw tab -t fwlic FWDALLAS
• B.  fw licprint FWDALLAS
• C.  cplic print FWDALLAS
• D.  cprlic print FWDALLAS
• E.  fw lic print FWDALLAS