How do you configure a hostname?

• A.Router (config)#hostname R1

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Select and Place:

Correct Answer:

Explanation:
The service port can be used management purposes, primarily for out-of-band management. However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol (DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ports_and_interfaces.html

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command how does the router respond?

• A.It immediately replaces the existing OSPF route in the routing table with the newly configured static route
• B.It starts sending traffic without a specific matching entry in the routing table to GigabitEthernetO/1
• C.It ignores the new static route until the existing OSPF default route is removed
• D.It starts load-balancing traffic between the two default routes

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2 while all other VLANs are to remain tagged.
Which command accomplishes this task?

• A.switchport trunk native vlan 67
• B.switchport private-vlan association host 67
• C.switchport access vlan 67
• D.switchport trunk allowed vlan 67

Comment: *

Name: *

Email: *

Verification: *

Which two network actions occur within the data plane? (Choose two.)

• A.Run routing protocols.
• B.Reply to an incoming ICMP echo request.
• C.Match the destination MAC address to the MAC address table.
• D.Make a configuration change from an incoming NETCONF RPC.
• E.Add or remove an 802.1Q trunking header.

Comment: *

Name: *

Email: *

Verification: *