Refer to Exhibit.

An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)

• A.ipv6 router 2000::1/128 2012::1
• B.ipv6 router 2000::1/128 2012::1 5
• C.ipv6 router 2000::1/128 2012::2
• D.ipv6 router 2000::1/128 2023::2 5
• E.ipv6 router 2000::1/128 2023::3 5

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?

• A.Option D
• B.Option B
• C.Option C
• D.Option A

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the effect of this configuration?

• A.All ARP packets are dropped by the switch
• B.Egress traffic is passed only if the destination is a DHCP server.
• C.All ingress and egress traffic is dropped because the interface is untrusted
• D.The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

Comment: *

Name: *

Email: *

Verification: *

Which two values must you specify to define a static route? (Choose two.)

• A.next-hop address or exit interface
• B.destination network and mask
• C.incoming interface
• D.source network and mask
• E.administrative distance of the route

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the AAA functions from the left onto the correct AAA services on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *