Refer to Exhibit.

Which action do the switches take on the trunk link?

• A.The trunk does not form and the ports go into an err-disabled status.
• B.The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
• C.The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
• D.The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

OSPF must be configured between routers R1 and R2. Which OSPF configuration must be applied to router R1 to avoid a DR/BDR election?

• A.router ospf 1
  network 192.168.1.1 0.0.0.0 area 0
  interface e1/1
  ip address 192.168.1.1 255.255.255.252
  ip ospf cost 0
• B.router ospf 1
  network 192.168.1.1 0.0.0.0 area 0
  interface e1/1
  ip address 192.168.1.1 255.255.255.252
  ip ospf network point-to-point
• C.router ospf 1
  network 192.168.1.1 0.0.0.0 area 0
  hello interval 15
  interface e1/1
  Ip address 192.168.1.1 255.255.255.252
• D.router ospf 1
  network 192.168.1.1 0.0.0.0 area 0
  interface e1/1
  ip address 192.168.1.1 255.255.255.252
  ip ospf network broadcast

Comment: *

Name: *

Email: *

Verification: *

Refer to exhibit.

Which statement explains the configuration error message that is received?

• A.The router does not support /28 mask.
• B.It is a broadcast IP address
• C.IT is a network IP address.
• D.It belongs to a private IP address range.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An extended ACL has been configured configuration failed to work as
intended Which two
changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose two )

• A.The ACL must be configured the Gi0/2 interface inbound on R1
• B.Add a "permit ip any any" statement at the end of ACL 101 for allowed traffic
• C.The source and destination IPs must be swapped in ACL 101
• D.The ACL must be moved to the Gi0/1 interface outbound on R2
• E.Add a "permit ip any any" statement to the begining of ACL 101 for allowed traffic.

Comment: *

Name: *

Email: *

Verification: *