After you deploy a new WLAN controller on your network, which two additional tasks should you consider?
(Choose two.)

• A.deploy load balancers
• B.configure additional vlans
• C.configure multiple VRRP groups
• D.deploy POE switches
• E.configure additional security policies

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the SNMP components from the left onto the descriptions on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The entire contents of the MAC address table are shown. Sales-4 sends a data frame to Sales-1.

What does the switch do as it receives the frame from Sales-4?

• A.Flood the frame out of all ports except on the port where Sales-1 is connected.
• B.Map the Layer 2 MAC address to the Layer 3 IP address and forward the frame.
• C.Insert the source MAC address and port into the forwarding table and forward the frame to Sales-1.
• D.Perform a lookup in the MAC address table and discard the frame due to a missing entry.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command, how does the router respond?

• A.It ignores the new static route until the existing OSPF default route is removed.
• B.It starts load-balancing traffic between the two default routes.
• C.It immediately replaces the existing OSPF route in the routing table with the newly configured static route.
• D.It starts sending traffic without a specific matching entry in the routing table to GigabitEthernet0/1.

Comment: *

Name: *

Email: *

Verification: *

Using direct sequence spread spectrum, which three 2.4-GHz channels are used to limit collisions?

• A.5, 6, 7
• B.1, 2, 3
• C.1, 6, 11
• D.1, 5, 10

Comment: *

Name: *

Email: *

Verification: *