Drag the descriptions of device management from the left onto the types of device management on the right.

Correct Answer:

Explanation

Cisco DNA Center Device Management
3. Monitor the cloud for software update
5. Uses CLI templates to apply a consistent configuration to multiple devices at an individual location
6. Uses NetFlow to analyse potential security threats throughout the network and take appropriate action on that traffic Traditional device management
2. Manages device configuration on a per-device basis
4. Security is managed near the perimeter of the network with firewalls, VPNs, and IPS
* Implements changes via an SSH terminal

Comment: *

Name: *

Email: *

Verification: *

Which IPv6 address block sends packets to a group address rather than a single address?

• A.FE80::/10
• B.FC00::/7
• C.2000::/3
• D.FF00::/8
  FF00::/8 is used for IPv6 multicast and this is the IPv6 type of address the question wants to ask. FE80::/10 range is used for link-local addresses. Link-local addresses only used for communications within the local subnetwork (automatic address configuration, neighbor discovery, router discovery, and by many routing protocols). It is only valid on the current subnet. It is usually created dynamically using a link-local prefix of FE80::/10 and a 64-bit interface identifier (based on 48-bit MAC address).

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which configuration issue is preventing the OSPF neighbor relationship from being established between the two routers?

• A.R2 should have its network command in area 1
• B.R1 has an incorrect network command for interface Gi1/0
• C.R2 is using the passive-interface default command
• D.R1 interface Gil/0 has a larger MTU size

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which configuration for RTR-1 denies SSH access from PC-1 to any RTR-1 interface and allows all other traffic?

• A.Option C
• B.Option A
• C.Option B
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the effect of this configuration?

• A.The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.
  Dynamic ARP inspection is an ingress security feature; it does not perform any egress checking.
• B.All ingress and egress traffic is dropped because the interface is untrusted
• C.Egress traffic is passed only if the destination is a DHCP server.
• D.All ARP packets are dropped by the switch

Comment: *

Name: *

Email: *

Verification: *