Which set of methods is supported with the REST API?

• A.GET, PUT, POST, DELETE
• B.GET, POST, MOD, ERASE
• C.GET, PUT, ERASE, CHANGE
• D.GET, POST, ERASE, CHANGE

Comment: *

Name: *

Email: *

Verification: *

An engineer is configuring SSH version 2 exclusively on the R1 router.
What is the minimum configuration required to permit remote management using the cryptographic protocol?

• A.hostname R1
  service password-encryption
  crypto key generate rsa general-keys modulus 1024
  username cisco privilege 15 password 0 cisco123
  ip ssh version 2
  line vty 0 15
  transport input ssh
  login local
• B.hostname R1
  ip domain name cisco
  crypto key generate rsa general-keys modulus 1024
  username cisco privilege 15 password 0 cisco123
  ip ssh version 2
  line vty 0 15
  transport input all
  login local
• C.hostname R1
  crypto key generate rsa general-keys modulus 1024
  username cisco privilege 15 password 0 cisco123
  ip ssh version 2
  line vty 0 15
  transport input ssh
  login local
• D.hostname R1
  ip domain name cisco
  crypto key generate rsa general-keys modulus 1024
  username cisco privilege 15 password 0 cisco123
  ip ssh version 2
  line vty 0 15
  transport input ssh
  login local

Comment: *

Name: *

Email: *

Verification: *

Which protocol supports sharing the VLAN configuration between two or more switches?

• A.STP
• B.split-horizon
• C.multicast
• D.VTP

Comment: *

Name: *

Email: *

Verification: *

What event has occurred if a router sends a notice level message to a syslog server?

• A.A certificate has expired
• B.An interface line has changed status
• C.A TCP connection has been torn down
• D.An ICMP connection has been built

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer has started to configure replacement switch SW1.
To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing.
Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

• A.SW1(config)#interface fa0/2
  SW1(config-if)#no switchport mode trunk
  SW1(config-if)#no switchport trunk allowed vlan 3
  SW1(config-if)#switchport mode access
• B.SW1(config)#interface fa0/2
  SW1(config-if)#no switchport access vlan 2
  SW1(config-if)#no switchport trunk allowed vlan 3
  SW1(config-if)#switchport trunk allowed vlan 2
• C.SW1(config)#interface fa0/2
  SW1(config-if)#no switchport access vlan 2
  SW1(config-if)#switchport trunk native vlan 2
  SW1(config-if)#switchport trunk allowed vlan 3
• D.SW1(config)#interface fa0/1
  SW1(config-if)#no switchport access vlan 2
  SW1(config-if)#switchport access vlan 3
  SW1(config-if)#switchport trunk allowed vlan 2

Comment: *

Name: *

Email: *

Verification: *