Refer to the exhibit. Which command provides this output?

• A.show cdp neighbor
• B.show ip interface
• C.show interface
• D.show ip route

Comment: *

Name: *

Email: *

Verification: *

What is a requirement when configuring or removing LAG on a WLC?

• A.The incoming and outgoing ports for traffic flow must be specified if LAG is enabled.
• B.The controller must be rebooted after enabling or reconfiguring LAG.
• C.The management interface must be reassigned if LAG disabled.
• D.Multiple untagged interfaces on the same port must be supported.

Comment: *

Name: *

Email: *

Verification: *

What are two southbound APIs? (Choose two )

• A.OpenFlow
• B.NETCONF
• C.Thrift
• D.CORBA
• E.DSC

Comment: *

Name: *

Email: *

Verification: *

Refer to Itie exhibit. A network engineer started to configure port security on a new switch. These requirements must be met:
* MAC addresses must be learned dynamically
* Log messages must be generated without disabling the interface when
unwanted traffic is seen
Which two commands must be configured to complete this task? (Choose two)

• A.SW(config-if)aswitchport port-security maximum 2
• B.SW(ccnfig-if)=switchport port-security violation shutdown
• C.SW(ccnfig-if)=switchport port-security mac-address sticky
• D.SW(confKj-if)=switchport port-security violation restrict
• E.SW(config.if)sswitchport port-security mac-address 0010.7B84.45E6

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which two statements about the network environment of router R1 must be true? (Choose two.)

• A.The 10.0.0.0/8 network was learned via external EIGRP.
• B.There are 20 different network masks within the 10.0.0.0/8 network.
• C.The EIGRP administrative distance was manually changed from 90 to 170.
• D.Ten routes are equally load-balanced between Te0/1/0.100 and Te0/2/0.100
• E.A static default route to 10.85.33.14 was defined.

Comment: *

Name: *

Email: *

Verification: *