Refer to the exhibit. Which next-hop IP address does Router1 use for packets destined to host
10.10.13.158?
Drag and Drop Question
Drag and drop the statements about AAA from the left onto the corresponding AAA services on the right. Not all options are used.

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?
Lab Simulation 5
All physical cabling between the two switches is installed. Configure the network connectivity between the switches using the designated VLANs and interfaces.
1. Configure VLAN 100 named Compute and VLAN 200 named Telephony where required for each task.
2. Configure Ethernet0/1 on SW2 to use the existing VLAN named Available.
3. Configure the connection between the switches using access ports.
4. Configure Ethernet0/1 on SW1 using data and voice VLANs.
5. Configure Ethemet0/1 on SW2 so that the Cisco proprietary neighbor discovery protocol is turned off for the designated interface only.