Free Access to Cisco.200-301.v2023-04-10.q443 with Valid Practice Test (Page 63)

Question 306

Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3.
What are possible reasons for this problem? (Choose two.)

A.All of the routers need to be configured for backbone Area 1.
B.R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3.
C.A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
D.The hello and dead interval timers are not set to the same values on R1 and R3.
E.EIGRP is also configured on these routers with a lower administrative distance.
F.R1 and R3 are configured in different areas.

Question 307

Refer to the exhibit. How does the router manage traffic to 192.168.12.16?

A.It chooses the EIGRP route because it has the lowest administrative distance.
B.It load-balances traffic between all three routes.
C.It chooses the OSPF route because it has the longest prefix inclusive of the destination address.
D.It selects the RIP route because it has the longest prefix inclusive of the destination address.

Question 308

By default, which virtual MAC address does HSRP group 14 use?

A.00:05:5e:19:0c:14
B.00:00:0c:07:ac:0e
C.04:15:26:73:3c:0e
D.00:05:0c:07:ac:14

Question 309

Refer to the exhibit. A network engineer started to configure two directly-connected routers as shown. Which command sequence must the engineer configure on R2 so that the two routers become OSPF neighbors?