Refer to the exhibit.

Which next-hop IP address does Routed use for packets destined to host 10 10.13.158?

• A.10.10.10.9
• B.10.10.12.2
• C.10.10.11.2
• D.10.10.10.5

Comment: *

Name: *

Email: *

Verification: *

How do TCP and UDP differ in the way that they establish a connection between two endpoints?

• A.TCP uses synchronization packets, and UDP uses acknowledgement packets.
• B.UDP uses SYN, SYN ACK, and FIN bits in the frame header while TCP uses SYN, SYN ACK, and ACK bits.
• C.UDP provides reliable message transfer, and TCP is a connectionless protocol.
• D.TCP uses the three-way handshake, and UDP does not guarantee message delivery.

Comment: *

Name: *

Email: *

Verification: *

Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.)

• A.It establishes a static route to the 172.16.3.0 network.
• B.It establishes a static route to the 192.168.2.0 network.
• C.It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
• D.It configures the router to send any traffic for an unknown destination out the interface with the address
  192.168.2.4.
• E.It uses the default administrative distance.
• F.It is a route that would be used last if other routes to the same destination exist.

Comment: *

Name: *

Email: *

Verification: *

What is a function of Wireless LAN Controller?

• A.register with a single access point that controls traffic between wired and wireless endpoints.
• B.use SSIDs to distinguish between wireless clients.
• C.send LWAPP packets to access points.
• D.monitor activity on wireless and wired LANs

Correct Answer: C

Explanation
Lightweight APs (LAPs) is devices require no initial configuration. LAPs use the Lightweight Access Point Protocol (LWAPP) to communicate with a WLAN controller (WLC), as shown in the below figure.
Controller-based APs are useful in situations where many APs are required in the network. As more APs are added, each AP is automatically configured and managed by the WLC.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. What is the prefix length for the route that router1 will use to reach host A?

• A./28
• B./27
• C./29
• D./25

Comment: *

Name: *

Email: *

Verification: *