Free Cisco 200-401 Exam Dumps Questions & Answers

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

• A.  router#show cdp neighbors
• B.  router#show ip route
• C.  router#traceroute
• D.  router#ping
• E.  router#tracert

A network administrator has subnetted the 172.16.0.0 network using a subnet mask of
255.255.255.192. A duplicate IP address of 172.16.2.120 has accidentally been configured on a workstation in the network. The technician on the plant floor must assign this workstation a new IP address within that same subnetwork. Which address should be assigned to the workstation?

• A.  172.16.2.127
• B.  172.16.1.64
• C.  172.16.2.128
• D.  172.16.1.80
• E.  172.16.2.80
• F.  172.16.2.64

At which Layer would you use trace route to validate the path?

• A.  Layer 3
• B.  Layer 2
• C.  Layer 4
• D.  Layer 1

What are two benefits of a star network topology? (Choose two.)

• A.  Any problem which leaves the network inoperable can be traced to the central hub.
• B.  This network type requires less cable as compared to linear bus topology.
• C.  Disruption of the entire network is not required when adding new machines.
• D.  The performance of one of the numerous nodes cannot reflect on the performance of other nodes.
• E.  The performance of the entire network is directly dependent on the performance of the hub.

Which two reasons make mesh bonding systems most effective? (Choose two.)

• A.  provide low-impedance noise-equalizing paths
• B.  cover wide areas
• C.  most cost-effective approach
• D.  create equipotential grounding systems
• E.  provide additional strength to floor structures