Free Cisco 200-601 Exam Dumps Questions & Answers

What is the purpose of Spanning Tree Protocol?

• A.  to enhance the functions of SNMP
• B.  to create a default route
• C.  to provide multiple gateways for hosts
• D.  to prevent routing loops
• E.  to maintain a loop-free Layer 2 network topology

You have reached the limit of IPv4 IGMP groups available on a Cisco IE 3000 switch that was deployed using the Express Setup. Which CLI command will increase the number of available IPv4 IGMP groups and multicast routes from 256 to 1000 on this switch?

• A.  switch(config)#sdm prefer routing igmp
• B.  switch(config)#sdm prefer vlan igmp
• C.  switch(config)#sdm prefer vlan
• D.  switch(config)#sdm prefer routing

Exhibit:

Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

• A.  IEEE1588 and PTP are important for ensuring real-time synchronization.
• B.  The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
• C.  CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
• D.  Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
• E.  EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
• F.  EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.

DRAG DROP

Correct Answer:

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?

• A.  Telnet is more difficult to use and configure than SSH.
• B.  Telnet encrypts only the login information, not the entire transmission.
• C.  SSH requires fewer network resources and no additional configuration.
• D.  SSH encrypts the login and session information.