Refer to the exhibit.

Spoke routers do not learn about each other's routes in the DMVPN Phase2 network. Which action resolves the issue?

• A.Remove default route from spoke routers to establish a spoke-to-spoke tunnel.
• B.Disable EIGRP split horizon on the TunnelO interface of the hub router.
• C.Configure a static route in each spoke to establish a spoke-to-spoke tunnel.
• D.Rectify incorrect wildcard mask configured on the hub router network command.

Comment: *

Name: *

Email: *

Verification: *

Which security feature can protect DMVPN tunnels?

• A.TACACS+
• B.IPsec
• C.RTBH
• D.RADIUS

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.
Which command must be configured to make VRF CCNP work?

• A.interface Loopback0
  vrf forwarding CCNP
• B.interface Loopback0
  ip address 10.1.1.1 255.255.255.0
• C.interface Loopback0
  ip address 10.1.1.1 255.255.255.0
  vrf forwarding CCNP
• D.interface Loopback0
  ip address 10.1.1.1 255.255.255.0
  ip vrf forwarding CCNP

Comment: *

Name: *

Email: *

Verification: *

Which two components are required for MPLS Layer 3 VPN configuration? (Choose two)

• A.Use LDP for customer routes
• B.Use MP-BGP for customer routes
• C.Use OSPF between PE and CE
• D.Use a unique RD per customer VRF
• E.Use pseudowire for Layer 2 routes

Comment: *

Name: *

Email: *

Verification: *

A CoPP policy is applied for receiving SSH traffic from the WAN interface on a Cisco ISR4321 router.
However, the SSH response from the router is abnormal and stuck during the high link utilization. The problem is identified as SSH traffic does not match in the ACL. Which action resolves the issue?

• A.Rate-limit SSH traffic to ensure dedicated bandwidth.
• B.Apply CoPP on the control plane interface.
• C.Increase the IP precedence value of SSH traffic to 6.
• D.Apply CoPP on the WAN interface inbound direction.

Comment: *

Name: *

Email: *

Verification: *