Refer to the exhibit.

Which two actions should be taken to access the server? (Choose two.)

• A.Modify distribute list seq 10 to permit the route to 192.168.2.2.
• B.Modify the access list to deny the route to 192.168.2.2.
• C.Modify the access list to add a second line of permit ip any
• D.Add a floating static route to reach to 192.168.2.2 with administrative distance higher than OSPF
• E.Add a sequence 20 in the route map to permit access list 1.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

• A.Use the icmp-echo command to track both default routes
• B.Use the same AD for both default routes
• C.Start IP SLA by defining frequency and scheduling it
• D.Start IP SLA by matching numbers for track and ip sla commands

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer implemented CoPP but did not see OSPF traffic going through it. Which configuration resolves the issue?

• A.ip access-list extended OSPF permit ospf any any
• B.class-map match-all OSFP match access-group name OSPF
• C.control-plane service-policy input COPP
• D.policy-map COPP class OSFP police 8000 conform-action transmit exceed-action transmit violate-action drop

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

R1 is connected with R2 via GigabitEthernet0/0, and R2 cannot ping R1. What action will fix the issue?

• A.Fix route dampening configured on the router.
• B.Replace the SFP module because it is not supported.
• C.Fix IP Event Dampening configured on the interface.
• D.Correct the IP SLA probe that failed.

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *