Refer to the exhibit.

An engineer cannot copy the IOS.bin
Which action resolves the issue?

• A.Add the IOS.bin file, which does not exist on FTP server.
• B.Make memory space on the switch flash or USB drive to download the file.
• C.Allow file permissions to download the file from the FTP server.
• D.Use the copy flash:/ ftp://[email protected]/IOS.bin command.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

• A.Use an extended access list instead of a standard access list.
• B.Use a prefix list instead of an access list in the route map.
• C.Add this statement to the route map: route-map RM-OSPF-DL deny 20.
• D.Change sequence 10 in the route-map command from permit to deny.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Network operations cannot read or write any configuration on the device with this configuration from the operations subnet. Which two configurations fix the issue? (Choose two.)

• A.Modify access list 1 and allow SNMP in the access list.
• B.Configure SNMP rw permission in addition to community ciscotest.
• C.Modify access list 1 and allow operations subnet in the access list.
• D.Configure SNMP rw permission in addition to community ciscotest 1.
• E.Configure SNMP rw permission in addition to version 1.

Comment: *

Name: *

Email: *

Verification: *

Refer to Exhibit.
A network administrator has successfully configured DMVPN topology between a hub and two spoke routers.
Which two configuration commands should establish direct communications between spoke 1 and spoke 2 without going through the hub? (Choose two).

• A.At the hub router, configure the ip nhrp shortcut command.
• B.At the spoke routers, configure the ip nhrp spoke-tunnel command.
• C.At the hub router, configure ip nhrp redirect the command
• D.At the spoke routers, configure the ip nhrp shortcut command.
• E.At the hub router, configure tne Ip nhrp spoke-tunnel command

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to 17.20.20.0/30 network?
A)

B)

C)

D)

• A.Option C
• B.Option B
• C.Option D
• D.Option A

Comment: *

Name: *

Email: *

Verification: *