Drag and drop the model driven telemetry characteristics from the left onto the mode they belong to on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Which design consideration should be observed when EIGRP is configured on Data Center switches?

• A.Prevent unnecessary EIGRP neighborships from forming across switch virtual interfaces.
• B.Perform manual summarization on all Layer 3 interfaces to minimize the size of the routing table.
• C.Lower EIGRP hello and hold timers to their minimum settings to ensure rapid route reconvergence.
• D.Configure multiple EIGRP autonomous systems to segment Data Center services and applications.

Comment: *

Name: *

Email: *

Verification: *

A network engineer is redesigning a company's QoS solution. The company is currently using IP Precedence, but the engineer plans to move to DiffServ. It is important that the new solution provide backward compatibility with the current solution. Which technology should the design include?

• A.assured forwarding
• B.default per hop behavior
• C.expedited forwarding
• D.class selector code points

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A customer needs to apply QoS to the network management traffic passing through the GigabitEthernet0/2 interface. All eight queuing classes are in use, so the new requirement must be integrated into the existing policy. Which solution must the customer choose?

• A.Mark traffic to DSCP CS5 and assign it to the SIGNALLING class. Then, baseline existing queue sizes to determine if additional bandwidth can be provisioned to the SIGNALLING class.
• B.Mark the traffic to DSCP CS4 and assign it to the SIGNALLING class. Then, prioritize traffic within the class.
• C.Mark the traffic to DSCP CS6 and assign it to the ROUTING class Then, prioritize traffic within the class.
• D.Mark the traffic to DSCP CS2 and assign it to the ROUTING class Then, baseline existing queue sizes to determine if additional bandwidth can be provisioned to the ROUTING class

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which two solutions maximize the use of the links between the core and distribution layers? (Choose two.)

• A.use an IGP
• B.use multiple equal-cost links
• C.use HSRP
• D.use RPVSTP+
• E.use multiple unequal-cost links

Comment: *

Name: *

Email: *

Verification: *