A branch office has a primary L3VPN MPLS connection back to the main office and an IPSEC VPN tunnel that serves as backup. Which design ensures that data is sent over the backup connection only if the primary MPLS circuit is down?

• A.Use OSPF with a passive-interface command on the backup connection.
• B.L3VPN MPLS and the IPSEC VPN tunnel.
• C.Use BGP with the multipath feature enabled to force traffic via the primary path when available.
• D.Use static routes tied to an IP SLA to prefer the primary path while a floating static route points to the backup connection.
• E.Use EIGRP to establish a neighbor relationship with the main office via

Comment: *

Name: *

Email: *

Verification: *

Which two border nodes are available in the Cisco SD-Access architecture? (Choose two.)

• A.extended border
• B.edge border
• C.internal border
• D.anywhere border
• E.intermediate border

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An architect must design a solution to connect the network behind R3 with the EIGRP network. Which mechanism should be included to avoid routing loops?

• A.route tags
• B.split horizon
• C.down bit
• D.summarization

Comment: *

Name: *

Email: *

Verification: *

An engineer is creating a design to enable IPv6 to run on an existing IPv4 IS-IS network. The IPv4 and IPv6 topologies will match exactly, and the engineer plans to use the same router levels for each protocol per interface. Which IS-IS design is required?

• A.single topology without enabling transition feature
• B.single topology with transition feature enabled
• C.multi topology with transition feature enabled
• D.multi topology without enabling transition feature

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the properties from the left onto the Cisco SD-WAN components that perform them on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *