What is the purpose of a control plane node in a Cisco SD-Access network fabric?

• A.to maintain the endpoint database and mapping between endpoints and edge nodes
• B.to detect endpoints in the fabric and inform the host tracking database of EID-to-fabric-edge node bindings
• C.to identify and authenticate endpoints within the network fabric
• D.to act as the network gateway between the network fabric and outside networks

Comment: *

Name: *

Email: *

Verification: *

A packet sent to a multicast address reaches what destinations?

• A.All hosts
• B.Reserved global destinations
• C.All destinations in a set of hosts
• D.The nearest destination in a set of hosts

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the model driven telemetry characteristics from the left onto the mode they belong to on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Which two options are primary functions of Cisco ISE? (Choose two.)

• A.enabling WAN deployment over any type of connection
• B.enforcing endpoint compliance with network security policies
• C.automatically enabling, disabling or reducing allocated power to certain devices
• D.providing information about every device that touches the network
• E.allocating cloud resources
• F.providing encryption for any type of mobile devices

Comment: *

Name: *

Email: *

Verification: *

What is the purpose of the fabric management plane in a Cisco SD-Access architecture?

• A.enable EID-to-RLOC mapping that is based on the BGP protocol
• B.create an underlay network that is based on the IS-IS routing protocol
• C.enable automation techniques for device deployments and configurations
• D.create LISP-based EID for the end-to-end solution that is offered by SD-Access

Comment: *

Name: *

Email: *

Verification: *