When is it advisable to provide dedicated control plane nodes within a Cisco SD-Access design?

• A.in a small deployment where border nodes are not required
• B.in a design where fabric edge nodes are unable to provide control plane functionality
• C.in designs without Cisco DNA Center
• D.when there is a requirement for frequent roaming of endpoints across fabric edge nodes

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the steps WAN Edge performs when on-boarded into the Cisco SD-WAN overlay from the left into the order they are completed on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Which design consideration should be observed when EIGRP is configured on Data Center switches?

• A.Perform manual summarization on all Layer 3 interfaces to minimize the size of the routing table.
• B.Prevent unnecessary EIGRP neighborships from forming across switch virtual interfaces.
• C.Lower EIGRP hello and hold timers to their minimum settings to ensure rapid route reconvergence.
• D.Configure multiple EIGRP autonomous systems to segment Data Center services and applications.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. PC-2 failed to establish a Telnet connection to the Terminal Server. Which solution allows PC-2 to establish the Telnet connection?

• A.Gateway-Router(config)#ipv6 access-list Default_Access
  Gateway-Router(config-ipv6-acl)#sequence 15 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
• B.Gateway-Router(config)#ipv6 access-list Default_Access
  Gateway-Router(config-ipv6-acl)#sequence 25 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
• C.Gateway-Router(config)#ipv6 access-list Default_Access
  Gateway-Router(config-ipv6-acl)#no sequence 20
  Gateway-Router(config-ipv6-acl)#sequence 5 permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet
• D.Gateway-Router(config)#ipv6 access-list Default_Access
  Gateway-Router(config-ipv6-acl)#permit tcp host 2018:DB1:A:B::2 host 2018:DB1:A:C::1 eq telnet

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which two points in the network must an engineer configure the ports for explicit trust when using a DiffServ model?

• A.B and E
• B.C and D
• C.A and D
• D.F and G

Comment: *

Name: *

Email: *

Verification: *