An infrastructure team is concerned about the shared memory utilization of a device, and for this reason, they need to monitor the device state.
Which solution limits impact on the device and provides the required data?

• A.IPFIX
• B.static telemetry
• C.on-change subscription
• D.periodic subscription

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer working for a private service provider with an employee ID: 4670:71:
451 must design a BGP solution based on:
* All traffic originating from AS100 must pass through AS200 to reach the NTP and DHCP server
* When a link failure occurs between R3 and R4, traffic must follow the R2-R9 link to reach the NTP and DHCP server.
Which solution must the design include?

• A.Routers R3 and R10 advertise a lower local preference for outgoing traffic and a higher AS-PATH value for incoming traffic.
• B.Router R6 influences the paths of R9 and R11 to the DC with a higher AS-PATH value.
• C.Routers R3 and R10 advertise an IGP metric into BGP during redistribution in both directions.
• D.Router R3 applies a local preference of 200 for R1. R2. R9. and R11 routers to reach the data center.

Comment: *

Name: *

Email: *

Verification: *

Which component of Cisco SD-Access integrates with Cisco DNA Center to perform policy segmentation and enforcement through the use of security group access control lists and security group tags?

• A.Cisco Application Policy Infrastructure Controller Enterprise Module
• B.Cisco Network Data Platform
• C.Cisco Identity Services Engine
• D.Cisco TrustSec

Comment: *

Name: *

Email: *

Verification: *

Which topology within a network underlay eliminates the need for first hop redundancy protocols while improving fault tolerance, increasing resiliency, and simplifying the network?

• A.Layer 2 topology
• B.routed access topology
• C.virtualized topology
• D.logical fabric topology

Comment: *

Name: *

Email: *

Verification: *

What are two purposes of the RPF check in multicast routing? (Choose two.)

• A.to ensure that multicast packets are dropped if they arrived on the interface used to route traffic to the destination address
• B.to ensure that multicast packets are forwarded if they arrived on the interface used to route traffic back to the source address
• C.to ensure that multicast packets are dropped if they arrived on the interface used to route traffic back to the source address
• D.to ensure that multicast packets are forwarded if they arrived on the interface used to route traffic to the destination address
• E.to ensure that multicast packets, no matter the interface they arrived on are forwarded out all interfaces

Comment: *

Name: *

Email: *

Verification: *