Free Access to Cisco.300-425.v2023-05-22.q116 with Valid Practice Test (Page 21)

Question 96

Which non-Wi-Fi interferer can be identified by Metageek Chanalyzer?

A.PDAs
B.jammers
C.smartphones
D.printers

Question 97

A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO. Which reason explains this behavior?

A.The AP is getting power from a power injector.
B.The switch is 802.3af capable.
C.The switch is PoE+ capable.
D.A redundant power supply is unavailable on the switch.

Question 98

Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

A.When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
B.When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
C.When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
D.When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Question 99

A customer has noticed that Client Band Select is enabled and no clients are utilizing the 5 GHz band. Which three parameters must be met to ensure that wireless clients use the 5 GHz band? (Choose three.)

A.Ensure that channel bonding is enabled on the WLAN.
B.Ensure that the co-channel interference has not exceeded -85 dBm.
C.Ensure that the UNII-2 extended channels are enabled on the 802.11a radios.
D.Ensure that the client is receiving RSSI above the minimum band select RSSI threshold.
E.Ensure that the client is dual-band capable.
F.Ensure that the WLAN has 802.11a enabled.

Question 100

Drag and drop the characteristics from the left onto the correct functionalities on the right.

Question 96

Question 97

Question 98

Question 99

Question 100

Download PDF File