A customer has multiple WLCs running N+1 redundancy with APs equally distributed. Only one WLC is a designated backup for all other WLCs so the customer must ensure that the most critical APs remain registered or get priority over other APs in case of a WLC failure. However, the customer notices on WLC failure that some critical APs remain unregistered What needs to be addressed in the design?

• A.AP fallback is not enabled on the backup WLC.
• B.AP failover priority is not enabled globally on the backup WLC.
• C.AP failover priority is not enabled globally on the failed WLC.
• D.AP fallback is not enabled on the failed WLC.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An enterprise has offices spread around the globe. The APs are connected to different controllers installed in separate datacenters. The IT team wants to allow clients to roam from controllers in group ABC to controllers in group XYZ. Which feature must be incorporated in the design to accomplish this task?

• A.switch peer group
• B.mDNS gateway
• C.mobility lists
• D.workgroup bridge

Comment: *

Name: *

Email: *

Verification: *

An engineer is designing a wireless network to support Cisco Hyperlocation. The customer indicated some How is the design adjusted?

• A.Add additional APs to all the comers of the site.
• B.Add more APs than indicated from the site survey spread across all areas.
• C.Run the site survey using -57d Bm as a threshold.
• D.Add an additional AP in the middle of the dense area.

Comment: *

Name: *

Email: *

Verification: *

Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?

• A.When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
• B.When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
• C.When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
• D.When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Correct Answer: B

Comment: *

Name: *

Email: *

Verification: *

A wireless consultant reviewing the installation of an old wireless network. The existing AireOS controllers are running software version 6.0.4539:44024. The customer is using OEAP and wants to keep this functionality. Which licenses should the consultant propose with the latest controller software version?

• A.Base
• B.Premium
• C.WPlus
• D.Advanced

Comment: *

Name: *

Email: *

Verification: *