What is an important consideration when implementing a dual SSID design for BYOD?

• A.After using the provisioning SSID, an ACL that used to make the client switch SSIDs forces the user to associate and traverse the network by MAC filtering.
• B.If multiple WLCs are used, the WLAN IDs must be exact for the clients to be provisioned and traverse the network correctly.
• C.SSIDs for this setup must be configured with NAC State-RADIUS NAC for the clients to authenticate with Cisco ISE, or with NAC State-ISE NAC for Cisco ISE to associate the client.
• D.One SSID is for provisioning and the other SSID is for gaining access to the network. The use of an ACL should not be enforced to make the client connect to the REAL SSID after provisioning.

Correct Answer: D

Comment: *

Name: *

Email: *

Verification: *

An engineer must use Cisco AVC on a Cisco WLC to prioritize Cisco IP cameras that use the wireless network. Which element do you configure in a rule?

• A.rate-limit
• B.mark
• C.permit-ACL
• D.WMM required

Comment: *

Name: *

Email: *

Verification: *

A user is trying to connect to a wireless network that is configured for WPA2-Enterprise security using a corporate laptop. The CA certificate for the authentication server has been installed on the Trusted Root Certification Authorities store on the laptop. The user has been prompted to enter the credentials multiple times, but the authentication has not succeeded. What is causing the issue?

• A.The laptop has not received a valid IP address from the wireless controller.
• B.The user Active Directory account is locked out after several failed attempts.
• C.There is an invalid 802.1X authentication policy on the authenticator.
• D.There is an IEEE invalid 802.1X authentication policy on the authentication server.

Comment: *

Name: *

Email: *

Verification: *

Which two events are outcomes of a successful RF jamming attack? (Choose two.)

• A.disruption of WLAN services
• B.unauthentication association
• C.deauthentication broadcast
• D.deauthentication multicast
• E.physical damage to AP hardware

Comment: *

Name: *

Email: *

Verification: *

An engineer must configure Cisco OEAPs for three executives. As soon as the NAT address is configured on the management interface, it is noticed that the WLC is not responding for APs that are trying to associate to the internal IP management address. Which command should be used to reconcile this?

• A.config flexconnect office-extend nat-ip-only disable
• B.config network ap-discovery nap-ip-only enable
• C.config flexconnect office-extend nat-ip-only enable
• D.config network ap-discovery nat-ip-only disable

Comment: *

Name: *

Email: *

Verification: *