Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?

• A.ip pim bidir-enable
• B.ipv4 pim bidir-enable
• C.ip multicast-routing
• D.ip pim bidir

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has configured all routers in the environment to run IS-IS Level 1 and Level 2 routing. The engineer wants traffic from R1 to R5 to pass via R2. but IS-IS routing has calculated the best path via R4.
Which action corrects the problem?

• A.Configure routers R1, R2, and R5 for Level 1 routing only.
• B.Set the link metric for the link from router R1 to router R4 to 30 or more.
• C.Set the link metric on R2 for the links from router R2 to routers R3 and R4 to 30 or more.
• D.Configure routers R1, R4, and R5 for Level 2 routing only.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Routers within the cluster are not receiving the desired prefixes.
What must be done to fix the issue?

• A.Clients in that cluster must have full mesh connectivity between eBGP peers.
• B.No client-to-client must be disabled.
• C.Clients in that cluster must have full mesh connectivity between iBGP peers.
• D.No client-to-client reflection must be enabled.

Comment: *

Name: *

Email: *

Verification: *

An engineer is troubleshooting slow performance issues on a customer's network after the last multicast configuration change was applied on it. While checking the running configuration on the router the engineer notices there are many ip igmp join-group commands applied on several interfaces of the router which caused the high CPU utilization usage.
What action must the engineer take to solve this issue?

• A.Remove ip igmp join-group command on all unnecessary interfaces
• B.Configure ip igmp static-group command on all interfaces
• C.Remove unnecessary members from the IGMP group
• D.Configure all router interfaces to be process-switched by increasing the query interval

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?

• A.Routes that have originated through AS 65517 have the local preference set to 150.
• B.Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
• C.Routes directly attached to AS 65517 have the local preference set to 150.
• D.Routes that have passed through AS 65517 have the local preference set to 150.

Comment: *

Name: *

Email: *

Verification: *