Refer to the exhibit. A network engineer configured routers R1 and R5 to run in IS-IS Level 1 mode and router R6 to run in IS-IS Level 2 mode. All other routers are running as Level 1 / Level
2 routers. An engineer expects traffic from R1 to R6 to pass via R2, but IS-IS routing has calculated the best path via R4. Which action corrects the problem?

• A.Configure all routers as Level 1 routers.
• B.Remove the link metric for the link from router R1 to router R2.
• C.Change the link metric for the link from router R1 to router R2 to 1.
• D.Configure all routers as Level 1 / Level 2 routers.

Comment: *

Name: *

Email: *

Verification: *

What are the two characteristics of route reflectors? (Choose two.)

• A.Routes received from nonclient peers are reflected to route renector cluster as well as OSPF peers.
• B.Routes received from nonclient peers are reflected to route reflector clients as well as nonclient peers.
• C.Routes received from a route reflector Client are reflected to other clients and nonclient peers.
• D.If a router received an iBGP route with the originator-ID attribute set to its owm router ID, the route is discarded.
• E.If a route reflector receives a route with a cluster-list attribute containing a different cluster ID, the route is discarded.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the relationship between Router 1 and Router 2?

• A.Router 2 is the head-end router in an SR-TE tunnel, and it is learning topology of the network from the PCE enabled on Router 1.
• B.Router 1 and Router 2 are participating in SR-TE tunnels and are both head-end routers.
• C.Router 1 and Router 2 centrally learn the topology of the network to aid in SR-TE path selection for peers.
• D.Router 1 centrally learns the topology of the network to aid in SR-TE path selection, and Router 2 is a node that feeds Router 1 topology information.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?

• A.Router 1 must define an explicit path to router 2
• B.Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
• C.Router 2 must have a tunnel interface created with router 1 as the destination
• D.Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the BGP attributes from the left into the order of route selection preference on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *