Refer to the exhibit. CE1 and CE2 are iBGP neighbors in AS 65516. All traffic that exits AS 65516 must use the link from CE1 to PE1. CE1 is advertising a higher local preference to CE2, but traffic from CE2 still prefers the PE2 link. Which action corrects the problem?

• A.Add the lower local-preference value on PE2 towards CE2.
• B.Configure CE1 to send routes to CE2 with a higher MED.
• C.Configure CE1 to send routes to CE2 with a higher weight.
• D.Add the next-hop self command to the CE1 neighbor statement for CE2.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. The extension header of the IPv6 header is ignored when which value is equal to zero?

• A.Segments Left
• B.Hdr Ext Len
• C.Routing Type
• D.Next Header

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. Network connectivity between bank A and bank B has been lost Users at bank A and bank B are able to successfully reach their directly connected PE routers. All routers in OSPF area 0 are correctly advertising and learning routing updates. Which action resolves the issue?

• A.Configure MPLS with an end-to-end label-switched path on each router.
• B.Configure router PI to advertise the IP prefix of PEI.
• C.Configure the P routers to redtstnbute BGP routes within OSPF area 0.
• D.Enable next-hop-self under the iBGP peering configuration on routers PEI and PE2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?

• A.The MED attribute can be applied on R2 to influence R1 to use it as the primary path.
• B.The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.
• C.The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.
• D.The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

R1 is expected to receive routes originating from AS 65516 and from any ASs that are directly attached to it. However, R1 is receiving routes only from AS 65516. Which action corrects the configuration?

• A.Change the regular expression in the AS-path permit filter to _65516_.
• B.Change the regular expression in the AS-path permit filter to ^65516_[0-9]*$.
• C.Add the regular expression ^$. in the AS-path filter to permit the traffic from R2.
• D.Change the regular expression in the AS-path permit filter to .*.

Comment: *

Name: *

Email: *

Verification: *