What is the difference between RPL and route map actions?

• A.RPL uses match, pass, set, and drop actions, and route maps use match, set, and drop actions.
• B.RPL uses match, set, drop, and stop actions, and route maps use match, set, and drop actions
• C.RPL uses pass, set, drop, and done actions, and route maps use match and set actions only.
• D.RPL uses pass, set, and drop actions only, and route maps use match, set, and drop actions.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?

• A.Configure the send and accept lifetime under key 1
• B.Change HMAC-MD5 to HMAC-SHA1-12
• C.Change HMAC-MD5 to MD5
• D.Change HMAC-MD5 to HMAC-SHA1-20

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer applied configuration on R1 to summarize all ISIS routes, but R2 Is still receiving specific routes from R1. The engineer has confirmed that both routers are configured with the correct summarization configuration, but R1 is not sending the correct summary routes. Which configuration must be applied to router R1 to summarize routes within Level 1?

• A.R1(config-router)#summary-address 1.0.0.0 255.0.0.0 level-2
• B.R1(config-router)#no summary-address 1.0.0.0 255.0.0.0 level-1
• C.R1(config-router)#summary-address 1.0.0.0 255.0.0.0 level-1
• D.R1 (config-router)#summary-address 1.0.0.0 255.0.0.0 level-1-2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. R1 is expected to receive routes originating from AS 65516 and from any ASs that are directly attached to it. However, R1 is receiving routes only from AS 65516. Which action corrects the configuration?

• A.Change the regular expression in the AS-path permit filter to ^65516_[0-9]*$.
• B.Add the regular expression ^$. in the AS-path filter to permit the traffic from R2.
• C.Change the regular expression in the AS-path permit filter to _65516_.
• D.Change the regular expression in the AS-path permit filter to .*.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which statement about this configuration is true?

• A.Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
• B.Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes
• C.Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
• D.Router 1 receives only the best path from neighbor 192.168.1.1

Comment: *

Name: *

Email: *

Verification: *