Refer to the exhibit. An engineering team implemented IS-IS on the network, with several different areas.
Recently, router R6 in area 3 has been experiencing excessive CPU usage. To reduce the load, a network engineer implemented route summarization on R2 However. R6 is still receiving the full routes from all routers. Which action must the engineer take to resolve the excessive CPU usage?

• A.Configure the Level 2 router R6 to manage summarization for the network
• B.Configure router R1 to send only the default route to R2 and R4.
• C.Configure all routers as Level 1/2 routers so that route summarization functions throughout the network
• D.Configure routers R3 and R5 to send summary routes to R6.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which two commands must the engineer configure for the company's PIM-PIM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface without affecting normal operation? (Choose two)

• A.enable sparse-dense mode
• B.enable Auto-RP announcements
• C.enable auto-rp listener
• D.enable sparse-mode
• E.enable dense mode

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. Which duplicate configuration causes this message during setup of an MPLS BGP network?

• A.ASNs
• B.originator ID
• C.cluster ID
• D.router ID

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Network connectivity between bank A and bank B has been lost Users at bank A and bank B are able to successfully reach their directly connected PE routers. All routers in OSPF area 0 are correctly advertising and learning routing updates. Which action resolves the issue?

• A.Configure MPLS with an end-to-end label-switched path on each router.
• B.Configure router PI to advertise the IP prefix of PEI.
• C.Configure the P routers to redtstnbute BGP routes within OSPF area 0.
• D.Enable next-hop-self under the iBGP peering configuration on routers PEI and PE2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?

• A.The MED attribute can be applied on R2 to influence R1 to use it as the primary path.
• B.The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.
• C.The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.
• D.The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.

Comment: *

Name: *

Email: *

Verification: *