Which two conditions must be met before separate ISPs can provide interdomain multicast routing? (Choose two.)

• A.Each ISP must configure MSDP to connect its individual multicast administrative domain to the domains at other ISPs.
• B.Each ISP must support intradomain multicast routing.
• C.Each ISP must replace its RP assignment with a global RP.
• D.Each ISP must dedicate a single router to handle multicast traffic between providers.
• E.Each ISP must configure its network to use PIM-DM.

Comment: *

Name: *

Email: *

Verification: *

Refer to me exhibit. A network engineer sets up a multihoming eBGP topology where multiple Autonomous Systems connect to ASN 64501.

The engineer wants to block all the routers coming from ASN 64502. but allow all the others. For that purpose, the following AS Pam prefix 1st s being used:
(config)#ip as-path access-list 10 deny _64502$
What must be fixed to achieve this result?

• A.The statement must be modified with ip as-path access-list 1 deny _64502_
• B.The AS-PATH filter must be defined inside the route-map mode
• C.The statement must CM modified with ip as path access list 1 deny A64502$
• D.At the end ip as-path access-list 10 permit .* must be included

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. The service provider operations team was alerted that hub site traffic from BGP AS
65101 to AS 65201 uses a non-primary path via the R5-R6 link. IBGP peering between R1 and R2 is up. and no fiber failure has been reported on the R2-R3 link The team determined that the traffic flow between
10.10.10.1 and 192.168.30.1 is not considering the R1-R2-R3-R4 path. Which action resolves this issue?

• A.Add metric 5 with BGP neighbor 10.10.10.6 on R5for receiving routes.
• B.Change the local-preference attribute to 50 with neighbor 10.10 10 5 on R1
• C.Change the metric attribute to 20 with neighbor 10.10.10.5 on R1.
• D.Set the local-preference to the default value with BGP neighbor 10 10.10.3 on R2 for receiving routes.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer working on a client's network is trying to solve the BGP community issue on R1 and R2 routers. After displaying the BGP entries, the engineer notices that both routers still have different outputs. Which action must the engineer perform to any of the routers to correct the problem and get the same output?

• A.Execute the lp bgp-community new-format command in Router1.
• B.Remove the lp bgp-community new-format command in Router1.
• C.Advertise the route to Router2 as standard community.
• D.Advertise the route to Router2 as extended community.

Comment: *

Name: *

Email: *

Verification: *

What are two features of dual-stack? (Choose two.)

• A.It supports IPv4 and IPv6 traffic on the same infrastructure.
• B.It allows an engineer to stack multiple Layer 2 switches to serve as a single switching unit.
• C.It requires tunneling IPv6 traffic over an IPv4 infrastructure.
• D.It securely routes and tunnels traffic between separate sites over the Internet.
• E.It is implemented without excessive processing power.

Comment: *

Name: *

Email: *

Verification: *