Refer to the exhibit. A Cisco ACI fabric uses L3Out to connect with R1. The 192.168.1.0/24 subnet is received over the physical interface Eth1/1 of Leaf1 and Leaf2. Which set of actions must be taken to receive the 2001:db8::2:1 subnet over the interface Eth1/1 interface?

• A.Create a new interface profile.
  Mark the IPv6 subnet as the export route control subnet.
• B.Create a new interface profile.
  Mark the IPv6 subnet as the import route control subnet.
• C.Use the current interface profile.
  Mark the IPv6 subnet as the export route control subnet.
• D.Use the current interface profile.
  Mark the IPv6 subnet as the import route control subnet.

Comment: *

Name: *

Email: *

Verification: *

What are two requirements for the IPN network when implementing a Multi-Pod ACI fabric? (Choose two.)

• A.OSPF routing
• B.VLAN ID 4
• C.EIGRP routing
• D.PIM ASM multicast routing
• E.BGP routing

Comment: *

Name: *

Email: *

Verification: *

An engineer must set up a Cisco ACI fabric to send Syslog messages related to hardware events, such as chassis line card failures. The messages should be sent to a dedicated Syslog server. Where in the Cisco APIC should the policy be configured to meet this requirement?

• A.uni/tn-common/monepg-default
• B.uni/infra/monifra-default
• C.uni/fabric/monfab-default
• D.uni/fabric/moncommon

Correct Answer: C

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/4-x/aci-fundamentals/Cisco-ACI-Fundamentals-401/Cisco-ACI-Fundamentals-401_chapter_01100.html

Comment: *

Name: *

Email: *

Verification: *

A network engineer must integrate VMware vCenter cluster with Cisco ACI. The requirement is for the management traffic of the hypervisors and VM controllers to use the virtual switch associated with the Cisco Application Policy. The EPG called "Vmware-MGMT" with VLAN 300 has been created for this purpose. Which set of steps must be taken to complete the configuration?

• A.Add VLAN 300 with static allocation to the VLAN POOL that is used for VMM integration.
  Attach the VMM domain to the target EPG with resolution preprovision, mode static, untagged access VLAN, and Port-Encap 300.
• B.Associate the target EPG with the VMM domain with default settings.
  Enable Infrastructure VLAN on AAEP used toward VMware hypervisors.
• C.Enable Infrastructure VLAN on AAEP used toward VMware hypervisors.
  Create a static binding in the target EPG toward VMware hypervisors with VLAN 300, untagged access VLAN, and Untagged 802.1P mode.
• D.Enable Infrastructure VLAN on AAEP used toward VMware hypervisors.
  Associate the target EPG with the VMM domain with default settings.

Comment: *

Name: *

Email: *

Verification: *

An administrator must migrate the vSphere Management VMkernel of all ESXi hosts in the production cluster from the standard default virtual switch to a VDS that is integrated with APIC in a VMM domain. Which action must be completed in this scenario?

• A.The administrator must create an in-band VMM Management EPG before performing the migration.
• B.The Management VMkernel EPG resolution must be set to Pre-Provosion.
• C.The VMkernel Management BD must be located under the Management Tenant.
• D.The administrator must set the Management VMkernel BD resolution immediacy to On-Demand.

Comment: *

Name: *

Email: *

Verification: *