Free Access to Cisco.300-620.v2024-07-11.q179 with Valid Practice Test (Page 33)

Question 156

An application team tells the Cisco ACI network administrator that it wants to monitor the statistics of the unicast and BUM traffic that are seen in a certain EPG. Which statement describes the collection statistics?

A.All EPGs in the Cisco ACI tenant object must be enabled for statistics to be collected.
B.Cisco ACI does not capture statistics at the EPG level. Only statistics that pass through ACI contracts can be monitored.
C.EPG statistics can be collected only for VMM domains. If a physical domain exists, statistics are not collected.
D.The collection of statistics is enabled on the EPG level by enabling the statistics for unicast and BUM traffic.

Question 157

In the context of ACI Multi-Site, when is the information of an endpoint (MAC/IP) that belongs to site 1 advertised to site 2 using the EVPN control plane?

A.Endpoint information is exchanged across sites when the endpoints are discovered in both sites.
B.Endpoint information is not exchanged across sites unless a policy is configured to allow communication across sites.
C.Endpoint information is not exchanged across sites unless COOP protocol is used.
D.Endpoint information is exchanged across sites as soon as the endpoint is discovered in one site.

Question 158

A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/ L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected. Which two requirements must be considered in this design? (Choose two.)

A.ACI underlay protocols, i.e. COOP, IS-IS and MP-BGP, spans across pods. Create QoS policies to make sure those protocols have higher priority.
B.A single APIC Cluster is required in a Multi-Pod design. It is important to place the APIC Controllers in different locations in order to maximize redundancy and reliability.
C.ACI Multi-Pod requires an IP Network supporting PIM-Bidir.
D.ACI Multi-Pod does not support Firewall Clusters across Pods. Firewall Clusters should always be local.
E.Multi-Pod requires multiple APIC Controller Clusters, one per pod. Make sure those clusters can communicate to each other through a highly available connection.

Question 159

A data center administrator is upgrading an ACI fabric. There are 3 APIC controllers in the fabric and all the servers are dual-homed to pairs of leaf switches configured in VPC mode. How should the fabric be upgraded to minimize possible traffic impact during the upgrade?

A.1. Create two maintenance groups for the APIC controllers: VPC left and VPC right.
2. Upgrade the first group of controllers.
3. Upgrade the second group of controllers.
4. Upgrade the leaf switches.
B.1. Create two maintenance groups for APIC controllers: VPC left and VPC right.
2. Upgrade the leaf switches.
3. Upgrade the first group of controllers.
4. Upgrade the second group of controllers.
C.1. Create two maintenance groups for the leaf switches: VPC left and VPC right.
2. Upgrade the APIC controllers.
3. Upgrade the first group of leaf switches.
4. Upgrade the second group of leaf switches.
D.1. Create two maintenance groups for the leaf switches: VPC left and VPC right.
2. Upgrade the first group of switches.
3. Upgrade the second group of switches.
4. Upgrade the APIC controllers.

Question 160

Refer to the exhibit. A syslog service was configured to capture different faults and events from a Cisco ACI tenant. The Cisco ACI fabric is missing any OOB capability. After some time, the administrator noticed that the syslog messages were not present on the APIC. Which two actions complete the configuration? (Choose two.)

A.Ping the syslog server from the APIC.
B.Change the minimum severity levels.
C.Change forwarding facility to local1.
D.Reconfigure the UDP port settings.
E.Set the management EPG to default.

Question 156

Question 157

Question 158

Question 159

Question 160

Download PDF File