Which command identifies the application and the user that have a Cisco Fabric Services session open?

• A.show cfs application
• B.show zoneset active
• C.show cfs lock
• D.show device-alias database

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer must configure the SAN telemetry streaming feature to stream statistics form a Cisco MDS 9000 Series Switch to two external receivers with the IP addresses 192.168.1.4 and 192.168.1.5.
Which two configurations accomplish this configuration? (Choose two.)

• A.Add dst-grp 200 under subscription 100.
• B.Add dst-grp 100 under subscription 200.
• C.Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group
  300.
• D.Add dst-grp 300 under subscription 200.
• E.Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group
  100.

Comment: *

Name: *

Email: *

Verification: *

Which result occurs if a device alias is renamed and then the original device alias name is used in an add command in the same session?

• A.The rename command is moved to the rejected list and the add command executes successfully.
• B.Both commands are moved to the rejected list.
• C.Both commands execute successfully.
• D.The device alias is renamed and the add command is moved to the rejected list.

Comment: *

Name: *

Email: *

Verification: *

Which port mode is used on an NPV device to connect to an NPIV core switch?

• A.NP
• B.N
• C.F
• D.E

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.


A storage network engineer activates a zoneset on MDS-A and verifies the successful activation (Exhibit 1).
The engineer is then notified that there is a SAN outage (Exhibit 2) What is the cause of the outage?

• A.Another network engineer activated the zoneset ZoneSetMDS-B-VSAN100 command on another switch in the fabric.
• B.Another network engineer issued the zone mode enhanced vsan 100 command on another switch in the fabric.
• C.Another network engineer issued the zone default-zone permit vsan 100 command on another switch in the fabric.
• D.Another network engineer activated zoneset ZoneSetMDS-B-VSAN100 on MDS-A.

Comment: *

Name: *

Email: *

Verification: *