Free Cisco 300-630 Exam Dumps Questions & Answers

What is a characteristic of a stretched bridge domain solution between Cisco ACI sites with Layer 2 flood disabled?

• A.  The application profile that is associated to the bridge domain have local significance in each site.
• B.  Headend replication is used for BUM traffic between sites.
• C.  IP mobility is ensured between sites for disaster recovery.
• D.  The tenant and VRF that associated to the bridge domain have local significance in each site.

An existing Cisco ACI Multi-Site setup with default fabric settings contains endpoints that communicate with an MTU of 1500. What is the minimum MTU value that must be supported by the ISN to allow control plane endpoint information exchange between sites?

• A.  9000
• B.  1554
• C.  1600
• D.  9100

Refer to the exhibit.

Which combination of flags in the Cisco ACI contract allows a client in WebClient EPG to establish an HTTP connection toward a server in WebServer EPG?

• A.  Apply Both Direction DISABLED and Reverse Port Filter DISABLED
• B.  Apply Both Direction ENABLED and Reverse Port Filter ENABLED
• C.  Apply Both Direction DISABLED and Reverse Port Filter ENABLED
• D.  Apply Both Direction ENABLED and Reverse Port Filter DISABLED

A Cisco ACI fabric Is configured with these settings:
* A single VRF exists that contains 100 EPGs.
* EPGs 1 to 50 must be permitted to communicate.
* EPGs 51 to 100 must NOT be allowed to communicate with EPGs 1 to 50.
* EPG 51 must be allowed to communicate with EPG 10.
Which two actions must be taken to accomplish these requirements? (Choose two.)

• A.  Select the Intra-EPG Isolation checkbox.
• B.  Create a standard contract between EPG 51 and EPG 10.
• C.  Enable the Preferred Group option on EPGs 1 to 50
• D.  Create a vzAny contract.
• E.  Set policy control enforcement to Unenforced.

Refer to the exhibit.

Server S1 is load balancing traffic received from SIP1 to BC1 and BC2. The Cisco ACI fabric must learn the IP address of S1 and unlearn the BC1 and BC2 IP addresses. Which two actions must be taken to meet these requirements? (Choose two.)

• A.  Create L4-L7 virtual IP of 10.14.2.7.
• B.  Suppress ARP response on BC1 and BC2.
• C.  Check the Limit IP learning to subnet box.
• D.  Enforce subnet check globally.
• E.  Disable IP data plane learning on EPG TLB