Free Cisco 300-710 Exam Dumps Questions & Answers

An engineer must perform a packet capture on a Cisco Secure Firewall Threat Defense device to confirm the MAC address of the host using IP address 192.168.100.100 while troubleshooting an ARP issue. What is the correct tcpdump command syntax to ensure that the MAC address appears in the packet capture output?

• A.  -nm src 192.168.100.100
• B.  -w capture.pcap -s 1518 host 192.168.100.100 mac
• C.  -w capture.pcap -s 1518 host 192.168.100.100 ether
• D.  -ne src 192.168.100.100

An engineer is deploying failover capabilities for a pair of Cisco Secure Firewall devices. The core switch keeps the MAC address of the previously active unit in the ARP table. Which action must the engineer take to minimize downtime and ensure that network users keep access to the internet after a Cisco Secure Firewall failover?

• A.  Add the MAC address to the switch ARP table.
• B.  Use a virtual MAC address on both units.
• C.  Run a script to send gratuitous ARP after a failover.
• D.  Set the same MAC address on both units.

An administrator is setting up Cisco Firepower to send data to the Cisco Stealthwatch appliances. The NetFlow_Set_Parameters object is already created, but NetFlow is not being sent to the flow collector. What must be done to prevent this from occurring?

• A.  Add the NetFlow_Send_Destination object to the configuration
• B.  Create a Security Intelligence object to send the data to Cisco Stealthwatch
• C.  Create a service identifier to enable the NetFlow service
• D.  Add the NetFlow_Add_Destination object to the configuration

An organization is implementing Cisco FTD using transparent mode in the network. Which rule in the default Access Control Policy ensures that this deployment does not create a loop in the network?

• A.  ARP inspection is enabled by default.
• B.  Multicast and broadcast packets are denied by default.
• C.  ARP packets are allowed by default.
• D.  STP BPDU packets are allowed by default.

Which Cisco Firepower Threat Defense, which two interface settings are required when configuring a routed interface? (Choose two.)

• A.  Speed
• B.  Redundant Interface
• C.  Duplex
• D.  Media Type
• E.  EtherChannel