Which action must be taken to permit communication between a bridge group and routed interface on Cisco Secure Firewall?

• A.Define a source NAT address.
• B.Create an access rule to allow the traffic.
• C.Create an ACL for the bridge group.
• D.Enable split tunneling.

Comment: *

Name: *

Email: *

Verification: *

Which policy rule is included in the deployment of a local DMZ during the initial deployment of a Cisco NGFW through the Cisco FMC GUI?

• A.no policy rule is included
• B.deny ip any
• C.permit ip any
• D.a default DMZ policy for which only a user can change the IP addresses.

Comment: *

Name: *

Email: *

Verification: *

An engineer must investigate a connectivity issue and decides to use the packet capture feature on Cisco FTD. The goal is to see the real packet going through the Cisco FTD device and see the Snort detection actions as a part of the output. After the capture-traffic command is issued, only the packets are displayed. Which action resolves this issue?

• A.Use the capture command and specify the trace option to get the required information.
• B.Specify the trace using the -T option after the capture-traffic command.
• C.Use the verbose option as a part of the capture-traffic command
• D.Perform the trace within the Cisco FMC GUI instead of the Cisco FTD CLI.

Comment: *

Name: *

Email: *

Verification: *

Which report template field format is available in Cisco FMC?

• A.box lever chart
• B.arrow chart
• C.bar chart
• D.benchmark chart

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A client that has IP address 192.168.67.102 reports issues when connecting to a remote server. Based on the topology and output of packet tracer tool, which action resolves the connectivity issue?

• A.Reconfigure NAT on FTDv.
• B.Restart the client-side application.
• C.Add the route to the destination.
• D.Unblock the access rule on FTDv.

Comment: *

Name: *

Email: *

Verification: *