Which method dynamically installs the network routes for remote tunnel endpoints?

• A.reverse route injection
• B.policy-based routing
• C.route filtering
• D.CEF

Comment: *

Name: *

Email: *

Verification: *

An engineer is troubleshooting a new DMVPN setup on a Cisco IOS router. After the show crypto isakmp sa command is issued, a response is returned of "MM_NO_STATE." Why does this failure occur?

• A.Tunnel protection is not applied to the DMVPN tunnel.
• B.The Phase 1 policy does not match on both devices.
• C.ESP traffic is being dropped.
• D.The ISAKMP policy priority values are invalid.

Comment: *

Name: *

Email: *

Verification: *

Which command is used to troubleshoot an IPv6 FlexVPN spoke-to-hub connectivity failure?

• A.show crypto identity
• B.show crypto isakmp sa
• C.show crypto gkm
• D.show crypto ikev2 sa

Comment: *

Name: *

Email: *

Verification: *

Which two changes must be made in order to migrate from DMVPN Phase 2 to Phase 3 when EIGRP is configured? (Choose two.)

• A.Add NHRP shortcuts on the hub.
• B.Add NHRP redirects on the spoke.
• C.Disable EIGRP next-hop-self on the hub.
• D.Enable EIGRP next-hop-self on the hub.
• E.Add NHRP redirects on the hub.

Comment: *

Name: *

Email: *

Verification: *

A network engineer is configuring a server. The router will terminate encrypted VPN connections on g0/0, which is in the VRF "Internet". The clear-text traffic that must be encrypted before being sent out traverses g0/1, which is in the VRF "Internal". Which two VRF-specific configurations allow VPN traffic to traverse the VRF-aware interfaces? (Choose two.)

• A.Under the virtual-template interface, add the ip vrf forwarding Internet command.
• B.Under the IKEv2 profile, add the match fvrf Internal command.
• C.Under the IKEv2 profile, add the ivrf Internal command.
• D.Under the virtual-template interface, add the tunnel vrf Internet command.
• E.Under the IKEv2 profile, add the match fvrf Internet command.

Comment: *

Name: *

Email: *

Verification: *