A network administrator is troubleshooting a FlexVPN tunnel. The hub router is unable to ping the spoke router's tunnel interface IP address of 192.168.1.2, even though the tunnel is showing up. The output of the debug ip packet CLI command on the hub router shows the following entry.
IP: tableid=0123456789 s=192.168.1.1 (local), d=192.168.1.2 (loopback2), routed via FIB.
What must be configured to fix this issue?
Refer to the exhibit.
A network engineer is reconfiguring clientless SSLVPN during a maintenance window, and after testing the new configuration, is unable to establish the connection. What must be done to remediate this problem?
Which VPN technology must be used to ensure that routers are able to dynamically form connections with each other rather than sending traffic through a hub and be able to advertise routes without the use of a dynamic routing protocol?
An engineer must design a remote access VPN solution that meet these requirements:
- supports use by telecommuters on the go
- encrypts user connections to the corporate network by using TLS-based tunnels
- is client-based
Which VPN technology must be used?
Which VPN does VPN load balancing on the ASA support?
