Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?
Why would RTP traffic that is sent from the originating endpoint fail to be received on the far endpoint?
Refer to the exhibit.
Calls incoming from the provider are not working through newly set up Cisco Unified Border Element.
Provider engineers get the 404 Not Found SIP message. Incoming calls are coming from the provider with called number "222333444" and Cisco Unified Communications Manager is expecting the called number to be delivered as "444333222". The administrator already verified that the IP address of the Cisco Unified CM is set up correctly and there are no dial peers configured other than those shown in the exhibit. Which action must the administrator take to fix the issue?
An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port
5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration?
(Choose two.)
Refer to the exhibit.
An administrator is troubleshooting a problem in which some outbound calls from an internal network to the Internet telephony service provider are not getting connected, but some others connect successfully. The firewall team found that some call attempts on port 5060 came from an unrecognized IP that has not been defined in the firewall rule. What should the administrator configure in the Cisco Unified Border Element to fix this issue?
