Free Cisco 350-001 Exam Dumps Questions & Answers

An expanding company is deploying leased lines between its main site and two remote sites. The bandwidth of the leased lines is 128kb/s each, terminated on different serial interfaces on the main router. These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs, and has therefore reserved sufficient bandwidth in a low latency queue on each interface for the VOIP traffic. Users now complain about bad voice quality although no drops are observed in the low latency queue. What action will likely fix this problem?

• A.  Configure the scheduler allocate 3000 1000 command to allow the OoS code to have enough CPU cycles
• B.  Enable Layer 2 fragmentation and interleaving on the links
• C.  Enable class-based traffic shaping on the VOIP traffic class
• D.  Mark VOIP traffic with IP precedence 6 and configure only fair-queue' on the links
• E.  Enable Frame Relay on the links and send voice and data on different Frame Relay PVCs

Refer to the exhibit.

While troubleshooting BGP in this network, you notice that routes are constantly flapping on R1.
What can be done to solve this issue?

• A.  Disable autosummary on R1 so that routes from R2 are installed in routing table.
• B.  Increase the EBGP multihop count to 3.
• C.  Disable synchronization on R1 so that routes from R2 are installed in the routing table.
• D.  Replace the static route on R1 with a specific route to 20.20.20.20/32.

Area Border Router (ABR) is a router located on the border of one or more OSPF areas that connect those areas to the backbone network. An ABR will inject a default route into which two types of areas? (Choose two.)

• A.  Totally stubby
• B.  Stub
• C.  NSSA
• D.  Area 0

The classic Spanning Tree Protocol (802.1 D 1998) uses which sequence of variables to determine the best received BPDU?

• A.  1) lowest root bridge id, 2) lowest sender bridge id, 3) lowest root path cost 4) lowest sender port id
• B.  1) lowest root bridge id, 2) lowest sender bridge id, 3) lowest port id, 4) lowest root path cost
• C.  1) lowest root bridge id, 2) lowest root path cost, 3) lowest sender bridge id, 4) lowest sender port id
• D.  1) lowest root path cost, 2) lowest root bridge id, 3) lowest sender bridge id, 4) lowest sender port id

According to the exhibit provided, what will be the purpose of this route map when applied to traffic passing through a router?

• A.  drop any packet sourced from 10.2.0.0/16
• B.  nothing; extended access lists are not allowed in route maps used for policy-based routing
• C.  take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1
• D.  take any packet sourced from any address in the 10.2.0.0/16 network and destined to
  10.1.14.25 and set the next hop to 10.1.1.1