Free Cisco 350-050 Exam Dumps Questions & Answers

Which two statements about the management access control on Cisco WLC, using an external TACACS+ server, are true? (Choose two.)

• A.  The Cisco WLC AAA authorization is role-based, using Cisco VSA attributes.
• B.  The Cisco WLC AAA authorization is role-based, using custom TACACS+ attributes.
• C.  The Cisco WLC requires the TACACS+ server to return a Privilege-Level attribute.
• D.  If a user is not entitled to a specific task, then the user is not allowed to access that task.
• E.  The Cisco WLC supports TACACS+ command authorization.
• F.  If a user is not entitled to a specific task, then the user is allowed to have read-only access to that task.

What is the MAPs behavior if you enable mesh ethernet-bridging vlan-transparent on them?

• A.  The MAPs bridge toward the backhaul only traffic that arrives as untagged on the Ethernet port.
• B.  The MAPs bridge traffic that came from the Ethernet port, but only if the vlan tag matches the Cisco WLC configured VLANs and interfaces.
• C.  The MAPs bridge traffic according to the VLAN configuration.
• D.  The MAPs untag all traffic that arrives on the Ethernet port and bridge all the traffic toward the backhaul.
• E.  The MAPs bridge toward the backhaul all traffic that arrives on the Ethernet port, without touching the vlan tag.

You want to expand the services of your wireless network and add location tracking on top of voice over wireless. Although the existing wireless network offers excellent voice over wireless services, tracking accuracy is not working well enough. You decide to contract a site survey engineer. What is this engineer most likely to recommend?

• A.  Disable 2.4 GHz and higher data rates, which interfere with location tracking.
• B.  Add wireless APs that are not from Cisco, to accomplish location tracking.
• C.  Install chokepoints to perform good location accuracy.
• D.  Add more APs to the perimeters of the floors.
• E.  Choose between voice over wireless and location tracking; you cannot use both simultaneously.

Refer to the exhibit.

What might be the reason of these failed attempts in ACS?

• A.  The request is coming from a AAA client that is configured only for RADIUS on ACS.
• B.  The wrong shared secret is configured on the AAA client or ACS.
• C.  The PC that is trying to access the device is outside the known subnet.
• D.  The request is coming from a AAA client that is configured only for TACACS+ on ACS.

Company XYZ needs to establish network connectivity to a newly acquired, adjacent building less than 1 kilometer (3280 feet) away. The project calls for implementing a wireless solution using autonomous access points in a point-to-point bridging solution using external antennas on interface dot11radio1. You need to secure the bridge link with strong EAP, DOT1x, and WPA methods, using a local RADIUS server. However, the link cannot be established and the following message is observed in the logs: "DOT1X_SHIM-3SUPP_START_FAIL: Unable to start supplicant on Dot11Radio1." What is most likely the root cause?

• A.  The non-root bridge is not configured for WPA key management.
• B.  The non-root bridge does not have the correct authentication credentials configured.
• C.  The RADIUS service on the root bridge is not started or needs to be restarted.
• D.  There is RF interference corrupting the 802.11b/g RF signal.